MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)
-   -   Help Drive line Pro's (http://forums.mustangworks.com/showthread.php?t=41602)

geno5.0 02-21-2004 08:50 AM

Help Drive line Pro's
 
I have a problem that only happens every once in a while??

When I disengage the Clutch at about 3/4th throttle from 2 to 3 I get kind of a bang! It does not make noise but it seem like the disengagement is fierce! Kind of like it is being thrown to the passenger side of the car!! I think my Tranny mount is shot but would this cause the feeling I am getting??


I installed a clutch about 8 months ago when I did the 5 speed swap. All the Dowels were in the flywheel. And I used lock tight on the flywheel bolts. And the clutch was tightened to spec. the Bell housing bolts all seem fine! The Clutch is a king cobra behind a car that is putting out around 280 hp so what do you think!

The only thing that I can think is that it is the tranny mount! It is OLD and covered in grease and crap.

429mustang 02-21-2004 09:24 AM

I'd check out the crossmember, a lot of them rust out especially where they bolt to the subframe.

geno5.0 02-21-2004 10:58 AM

I got under there the Xmember looks good but when I push the tranny with my hand the Tranny mount moves around alittle could that cause the felling I am feeling?:confused:

BLACK85GT 02-21-2004 05:01 PM

did you check the motor mounts too?


All times are GMT -5. The time now is 06:23 PM.