MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Modular Madness (http://forums.mustangworks.com/forumdisplay.php?f=17)
-   -   96 gt intake break??? (http://forums.mustangworks.com/showthread.php?t=42206)

Tony Frank 03-29-2004 12:52 PM

96 gt intake break???
 
So about a few months ago i picked up a 96 gt 80,000 miles five speed as a daily driver, its completley stock...

it all goes bad when im driving and i start to see a smoke in the rear view mirror. i stop and its pouring from under my hood, i pull over and the valley between the heads is filled with coolant....

take it to the shop and i find out that the intake is cracked on the front coolant runner. so i decide to get it fixed....850 bucks....

after getting my car back i do a recall check. sure enough ford says that they will fix the problem only if it does in fact break....within 7 years...

this sucks because the car is now 8 yrs old. do any of you guys think that i could get ford to reimburse me any amount of money???

or do any of you guys have the same story as i do? any info would be greatly apriciated..

91LX2Bfast 03-29-2004 05:02 PM

Definately try to see if Ford will cover at least part of it. The worst thing that'll happen is they won't. It has happened to many, many Mustang/T-bird/Cougar owners.
Its a shame you weren't around the forums before, because you could have replaced it with a PI intake with complete swap/adapter kit from Livernois for about $650. You would have got an aluminum crossover that won't break again, and picked up 10-15hp along the way.

Tony Frank 03-29-2004 09:02 PM

Well the car was here at school with me, and i wouldnt have had the time to wait for the part to be shipped, and the new ford intake has the alum. coolant runner.

i really didnt want to put aftermarket products on this car because im planning on keeping this bone stock..... im currently bugeting for a 347stroker for my 85

also the part itself from ford only cost me 550. when all said and done all together cost me 850.

i usually do the work myself but im not at home where my tools and stuff are. so i took it to the shop i use to work at.


All times are GMT -5. The time now is 08:14 PM.