Need help from someone with a groundpounder k member
 

I installed a ground pounder K member on my mustang. I can't get it lined up. One wheel is farther forward than the other. The engine tilts too one side, and the engine is about an inch too far back because my driveshaft will not fit anymore. I have the motor sitting in the first slot. I ma not using the 1" back slot on the k member. I need to see if this is normal or do I have another problem.

Something is wrong. Are you sure you have your motor mounts on the right sides? Can you post pics? You should not have to alter your ds. You said you were in indy, if so where maybe I can come over and take a look at it.