tps??
 

ok i knwo how to set the tps but when you have to moce it what moves does the hole thing move or what.

my tps is curently at .32 to .29 and it should be at about .98 tight??

i just dont knoiw what to move

anything will help thanks
mike

Loosen both screws on it and move the entire housing. It is very sensitive and can be a bitch to get set exactly right at times.

get it as close to 1 as u can w/out going over - thats what ive always done so yeah .98 or .99 is good

Yep move the whole plastic housing.

You should notice a big difference in throttle response once you get that set properly. Mine is currently at 0.97, and wass a biatch to set. It was a 0.8X and noticed a difference when I fixed mine, you're car must be running like crap being at 0.3x.

Tight
 

To help with the adjustablilty some remove the TPS and oversize the holes a bit with a drill. Yes a properly adjusted TPS is key.

After setting it you may want to reset the idle.

ok thanks to everyone but i can only move it like 2-3 cm back and forth is this right or should it move more then that.

thanks agian for teh help
mike

2-3 cm will me more than enough. It is very sensitive.