good deal or not??
 

ok this is the deal i got.

a set of gt 40p heads and a stock 302 out of an explorer oh ya and the intake came with it for an extra 100$ but anyways i piad 250 for everything .

now
this is what i am gunna do to the heads i am gunna get them shaved not sure how much ? (any ideas) and a 3 angle valve job done does that seem to be good or is there anything else i should do just let me know thanks

mike

good deal for the price and what you got!!! how many miles?

km's is unknown but i am planning on a 3 angle valve job and shaving them
do you know how much i should go with shaving them?? and is there anything else i should do to the heads?

oh ya and my intake its a explorer intake i am wanting to port it ab bit should thanks

thanks mike

Good deal...are you planning on using the explorer bottom end or installing the heads and intake on the motor you already have? I know the cam that's in the explorers isn't the greatest so I would say change it. Also I would port the exhaust side of the heads while you have it apart. The intake flows pretty well and should nearly match the intake runners on the heads. I think you have to mod the intake for one of the sensors but can't remember exactly what all you have to do.
-Ryan

no i am going to use my pistons and cam i have a f-cam. the intake ya you must do sumthing like that i have a site on what to do. to port the exhaust side just take the hump out right??

anything else you think i should do ??

thanks mike