70 mach 1 instrument panel
 

I do not have any working instruments on my instrument panel. There is clearly visible a small black broken wire in the vicinity of the pig tail that plugs into the printed circuit. Does anyone know where this wire connects? I am thinking it must be some sort of power wire that connects into one of the slots on the plug but do not know which one. Thanks.

Re: 70 mach 1 instrument panel
 

First check and see if you have a fuse blown. Then look around where the broken wire is, you should be able to find the other end it broke off from. It should be really close to the pigtail.

Re: 70 mach 1 instrument panel
 

Harold,

Thanks for the reply. I took your advise and looked for another broken end but was unable to find one. Could it have possibly pulled out of one of the connecting post? If so how would I be able to tell which one? Other than the obvious that there is not an empty slot. Could there have possibly been two wires going to the same place?
Thanks again for your help.