MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)
-   -   got my new slicks tonight!! (http://forums.mustangworks.com/showthread.php?t=45465)

82 GT 02-26-2005 12:24 AM

got my new slicks tonight!!
 
I picked up my M/T drag slicks tonight!!
The sticker on them says they are "tube type". Do I have to have inner tubes installed or is that what they recommend?

ols0051 02-26-2005 09:05 AM

Re: got my new slicks tonight!!
 
I didn't put tubes in my 26x10.5 et streets. They are on 15x8 welds, they don't leak at all. And have had no problems.

Dark_5.0 02-26-2005 12:17 PM

Re: got my new slicks tonight!!
 
I have seen the ET drags with no tubes. They work fine

lx mike 02-26-2005 06:10 PM

Re: got my new slicks tonight!!
 
I run mine without tubes and works fine. wait till you drop the clutch on them! :D

82 GT 02-26-2005 07:13 PM

Re: got my new slicks tonight!!
 
How much of an E.T gain do you think I'll get with slicks?
Will my 60' improve a lot?

tireburner163 02-27-2005 12:38 AM

Re: got my new slicks tonight!!
 
In a word.....YES!!!!!!!!!

I run 8.7's in the 1/8th on street tires, I run 8.0's on slicks

82 GT 02-27-2005 01:56 PM

Re: got my new slicks tonight!!
 
Ok, now how much tire presure should I run in them and is there anything special I should do to "break them in"?
I never had slicks before.

lx mike 02-27-2005 08:50 PM

Re: got my new slicks tonight!!
 
i set mine a lb or so lower than i want them to be cause the burnouts raise the temp and pressure. i start around 12-13 psi. pull through the waterbox so your not sirectly in the water just on the damp part. burnout till you can see some smoke in your mirror. don't do any dry hops just go to the line. power brake it as high as you can and hold on!! I picked up a tenth in my 60' times my first pass on slicks. went from 1.8's to 1.7's and now with a few more changes i 60' in the low 1.6's.

82 GT 02-27-2005 11:09 PM

Re: got my new slicks tonight!!
 
So..I should power brake at the line instead of mashing the gas?
I usually just set there on the line at idle and then punch it.
Hmm..I'll try your way and see what happens.
My track doesn't open until March 20th anyway........
Thanks for the advise

ols0051 02-28-2005 12:59 AM

Re: got my new slicks tonight!!
 
I started @20psi and worked my way down until I got the results I was looking for. Ended up @10psi. Gained a half a sec.

USMC302 02-28-2005 02:33 PM

Re: got my new slicks tonight!!
 
I run 9lbs in the drag radials and dump the clutch around 2200. let us know how the slicks do, I was putting them off for fear of the stock axles letting go.

lx mike 03-02-2005 03:39 PM

Re: got my new slicks tonight!!
 
Quote:

Originally Posted by 82 GT
So..I should power brake at the line instead of mashing the gas?
I usually just set there on the line at idle and then punch it.
Hmm..I'll try your way and see what happens.
My track doesn't open until March 20th anyway........
Thanks for the advise


Try diff ways of launching, try how you usualy then start getting more agressive each run.


All times are GMT -5. The time now is 11:06 AM.