What distributor to use
 

I have been having trouble with my stock distributor it will just cut out under full load and come back. Now it is dead I tried replacing the module and nothing,so I just want to replace it all together with a good aftermarket, the is a 89 5.0, I just want to eliminate the computer hookup to the distributor and go either mechanical or vacum advance. I have a Crane ignition box and coil. what distributor works great in the 5.0 that is not connected to the computer.
Thanks

Re: What distributor to use
 

Msd, Crane, Or Stock Vac. Adv. Would Work With Your System...........

Re: What distributor to use
 

I have msd8582(I think)Mech advance, works in conjunction with my msd box and blaster3 coil. It's a stand alone system. Pain to get the correct roller gear installed. sent it to msd to be changed took almost 2 mos, to get it back...but now all is good.

Re: What distributor to use
 

WHat car are you using this on. And what do you mean by the right roller gear.
Thanks

Re: What distributor to use
 

I Have A 91 Roller Block And Roller Cam With An 82 Machanical Dist. Didnt Change The Gear On It Very Little Wear On The Gear Its Been Like This For A Couple Years No Problems...........the Dist.goes Striate To The Msd Box So You Can Bypass The Computer In Your Car..........
\

Re: What distributor to use
 

Now your still using a Carb correct. will bypassing the distributor hookup on a EEC-4 with a mechanical advance msd and mass air mess up the computer
Thanks

Re: What distributor to use
 

You Should Not Have Any Problems But Im Not For Sure Post Another Asking That Question And See What People Say............