need some help advice for my 4.6
 

Hi, i am an owner of a 1996 Mustang Gt with some work done to it and wanted to know what would be best to do next and what cams and heads would be best for it also. Just to give you an idea of what its got already its got, BBK long tube headers, off road h-pipe, two chamber Flowmasters, 3” stainless tips
Steeda billet flywheel, King Cobra clutch, Steeda adjustable clutch quadrant, Tremec T-45 5sp., FRPP aluminum driveshaft, Auburn Pro Series differential w/FRPP 4:10’s, Superior hardened axles, Pro 5.0 short throw, Flameball illuminated shift knob
Eibach Sportline springs, KYB shocks and struts, Steeda strut tower brace, painted brake calipers, Powerstop cross-drilled front rotors w/Hawk pads
FRPP 70mm throttle body, Steeda underdrives, UPR cold air intake, BBK adjustable fuel pressure regulator, FRPP 9mm wires, Diablo Sport chip, NOS 150hp kit w/dual side purge, Lokar dipstick tube, various chrome engine pieces, Ford 200A chrome alternator, Optima Red Top battery and it has 46,000 original miles.
I would appreciate the help, Thank You

Re: need some help advice for my 4.6
 

How much power is it making now? At the tire? We see a lot of the 4.6's and have seen various stages of power.

Ron

Re: need some help advice for my 4.6
 

LMAO :D
But on a serious note your best bet is a PI head swap, or ported PI heads and a good set of cams. You'd see a good bump in compression ratio plus the added airflow would yield good results.