i need heads
 

does anyone have a set of heads they would sell for reasonable price either stock or aftermarket for a 302

Re: i need heads
 

What's a reasonable price?

Re: i need heads
 

i am looking for the 500-700 dollar range

Re: i need heads
 

Ebay! Look for "Windsor Jr." Iron is OK on these heads. I had a set, and WOW!

Re: i need heads
 

what do you think of tristate cylinder heads they sell pro topline has anyone used any of these heads and if so good or bad results

Re: i need heads
 

I have a good set of "stock" cylinder heads.

Re: i need heads
 

which ones e7s or others and how much

Re: i need heads
 

I've got the aluminum 200cc PTL's on my car, times in sig. I like them. If you're serious about it, I'd look into the 180cc version, but you're going to pay more than $700 for them

Re: i need heads
 

Here you go..check out this page. A set of fresh windsor Jr's for $700
http://www.fordmuscle.com/classified...ad.php?id=3682

Re: i need heads
 

Yep, they are E7's. I think that shipping them will be $$$ because of the weight. I'm in Orlando, FL.

Re: i need heads
 

I have a set of 351W heads that I ran for several years on my 306 engine. The only reason that they were removed was because I wanted TFTW aluminum heads.

The 351W heads were used for about 20,000-25,000 miles over a 4 year period. These heads are professionally pocket ported and gasket matched with a 3 angle valve job. The valves measure 1.85 intake/ 1.55 exhaust. The heads were angle milled to produce a 59.5 cc chamber. With flat top pistons that should make 9.5/1 CR on the 302. These heads also include Comp Cams 1.6 ratio roller tip Magnum rocker arms ($139 value new).

About a year ago, I thought I had the heads sold. At that time, I took them back to the shop that built them originally. They were disassembled, cleaned, and inspected at that time. No problems were found. They did do a touch up vave job just because they had them apart.

I would sell these heads for $400 + shipping. Pm me for further questions if interested. BTW. I think my 306 made approximately 300 HP with these heads.

Rev

Re: i need heads
 

Just my $.02, that's a KILLER deal. You'd have twice that in building them. ;)

Re: i need heads
 

Yeah, but there're stock sized valves. I would look for something with at least 1.94/1.60 valves.
Sorry REV, I'm not trying to screw you out of a sale....just stating my opinion.
I would either buy those Windsor Jr. heads I showed the link for or save your money for a nice aftermarket set of heads.

That's what happened to me....I was all excited two years ago to get my engine built, I didn't have about $1500 for aluminum heads so I spent $700 on my stock 351 heads getting them ported, polished and 1.94/1.60 valves installed. If I would have been patient and saved another $700, I could of had the aluminum heads.
Now, I'm at the crossroads where I need better flowing heads and the saving process starts all over again for heads.....that I should of had two years ago.
Take some good advise by saving and buying the aftermarket heads NOW instead of wishing you would have done it a long time ago.