9 inch ford???????
 

Does anyone have any suggestions on how to get the front housing off of one of these things? I'm helped a buddy of mine pull his rear end out so we'd have more room to work with it. It just seems like its in a bind. We've been working screwdrivers in all around it and we got it about a 1/4 of an inch off but thats about it. Any body come up with a good way to get these off?

------------------
95gt 80k, MSD 6AL, MSD coil, pulleys, fpr, cold air kit, off road h-pipe, flowmasters, 3.73, 9mm wires, mega bite jr lowers, kennybrown subframe connectors, edelbrock performer intake, 70mm TB, 73mm C&L, 24lb injectors Aluminum Driveshaft, Tri-Ax shifter.

Did you pull both axles out of the housing, first? If the axles are out, pry from two opposing sides of the third-member at the same time, so that the third-member comes out of the housing evenly.

The third member wasn't the problem. It was just getting the cover of that was a pain. We got it off now thanks for the help!

------------------
95gt 80k, MSD 6AL, MSD coil, pulleys, fpr, cold air kit, off road h-pipe, flowmasters, 3.73, 9mm wires, mega bite jr lowers, kennybrown subframe connectors, edelbrock performer intake, 70mm TB, 73mm C&L, 24lb injectors Aluminum Driveshaft, Tri-Ax shifter.

I wasn't aware that ford 9" rears had a cover. Unless it's custom made and it;s on the back. The third member pulls out the front as far as I'm aware. And that's the only access point to the rear end. Maybe you have an 8.8 which has a cover on the rear.(I think)

------------------
1969 fast back; yellow; weld wheels; 302 roller with GT-40 heads; 3:55 gears; 5spd T-5; MSD 6AL; E-303; flows