new heads
 

its official, i now have the edelbrock performer rpm intake and cylinder heads installed. man is the car flippin sweet. it rips all the way to the 6000 rpm limiter. i will hopefully be dynoing the car this weekend at CSA dyno performance. its a mustang dyno so it gives lower numbers. anybody have any guesses on hp or tq. chime in if you have an idea.
65mm TB
perf rpm intake
perf rpm heads(1.90 in 1.60 ex)
E-cam
stock 118,000 mile bottom end

Re: new heads
 

Did you ever buy that engine with the windsor jr. heads?

Re: new heads
 

I'll guess 293/310 at the wheels :D

Re: new heads
 

couldn't do both so i went with the heads instead of the new motor, this time i replaced the pushrods and lifters, i also went with harland sharp 1.6 rr's. 293/310 sounds good i definitely want 300 to the ground but also realize thats pushing it. we'll be keeping the fingers crossed.

Re: new heads
 

I have to ask, why new heads, on a stock bottem end?

Re: new heads
 

Why not? Good heads and headers knock almost a full second of my 1/4 times, went from 93mph in the Az summer to almost 103mph in the heat. Still have the stock cam too. Stock 95 engine.

Re: new heads
 

on a mustang dyno i will bet 270rwhp. should be a solid 12 second car. low or high 12s is dependant on your hook and your driving.