Gasket matching
 

I will be buying heads and intake and had some questions about gasket matching. Correct me if i am wrong. You match the intake port on the heads and the ports on the lower intake to a certain gasket. Now what do i use to see how much needs to be taken out to be matched to the gasket? Is there anything else i can do to get the most out of my combo before i put it on? Heads will be trick flow twisted wedge and intake is the street heat. Thanks in advance.

------------------
90 GT 150k on the motor never had the valve covers off, 1 5/8" headers, x-pipe, 2chamber flowmaster,fms aluminum ds, 3.55, best time on 245/45/17 2.08 60', 13.906 @ 98.98

Go to sn95.com it is in tech corner under outside tech topic.hope this help.