MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)
-   -   Code 24 (http://forums.mustangworks.com/showthread.php?t=4978)

Jeff7477 08-05-2001 10:35 PM

Code 24
 
I ran a KOER check earlier, and got a code 24. It is coolant temp sensor out of specified range. The car wasn't warmed up at all, could this be it?

jimberg 08-05-2001 11:38 PM

The answer to your idle question? That would be the the air charge temperature sensor and it can absolutely cause idle problems. It is located by the #5 injector and has a big round connector going to it.

http://people.mn.mediaone.net/jimber...ideSensors.jpg

------------------
351W 89 Mustang GT Convertible

Capri306 08-05-2001 11:39 PM

Damn, jimberg beat me again!!!!!!!! http://www.mustangworks.com/msgboard/wink.gif

You're supposed to have it up to operating temperature when performing a KOER test, and for extra measure the EGOs should be up to temperature as well (so it's in closed loop). This consists of running the engine at 2000rpm for 2 minutes, AFTER the engine is up to op-temp.

Charles Probst's book says Code 21 means 'ECT our of Self-Test range.' Did you just get this code during the KOER test only or in the KOEO, too? If the engine was cold, redo the test and confirm the results.

[This message has been edited by Capri306 (edited 08-06-2001).]


All times are GMT -5. The time now is 05:24 PM.