How to jet an Edelbrock 1405 Carb ?
 

i just picked up the complete jet kit from edelbrock, comes with all the little gizmos to tune the carb...

does anyone know exactly what is involved in re-jetting this carb?


FORD !

------------------
5.0L 89 LX coupe
4.10 gears, CARB !!!
IM me at FORDFASTER

It's real easy...

1. Take the top of the Carb off.
2. The jets are in the back corners.

Carefull not to mess up the floats - They are really CHEAPO on the Edelbrocks...

This Carb is the easiest to rebuild! There is nothing to it! Not 3,000 gaskets, checkballs ect. like on a Holley...

Not hard - just take your time...

Thanks for the reply !

i was wondering if you knew which jets to use if i wanted to go one step leaner than stock jetting... i have a NASTY bog under 3500 rpms.. and i also have a crane 2040 cam, which is the exact same grind as an E303 FMS cam and comp cams racing valve springs......

i have a torker II, 302 intake.. and shorty headers with off-road h-pipes and 2 chamber flowmasters with dumps, a 5 speed nad 4.10 gears with FMS drive shaft... eibach drag springs... jetting suggestions ?