Throttle Body Installation
 

I got it all done, everything was easy. The problem I have was setting the voltage on the positioning sensor. How exactly do you do it. I thought the car was running great but then I checked the voltage on it. The voltage read .58 (I know, its supposed to be like .98). I loosened the screws but couldn't spin the top piece. I got the voltage to .630 with the little I could do, but it couldn't go farther. How do I get the voltage to where it needs to be? Maybe I'm doing it wrong.

------------------
1993 Mustang GT - March Ram Air & Pullies, K&N, C&L 73mm MAF, 3.73 Gears, Super Competition Hooker Headers, 2 1/2 in. High Flow H-Pipe & 2 1/2 in. Flowmaster Cat Back, Pro 5.0 Shifter, 16* Timing Advance, 8.5mm MSD Super Cunductor Plug Wires, Romoved front Sway Bar, Pro-Shift Lite, LX lights

your have to drill the holes bigger untill you get the correct voltage. drill a little at a time!

Honestly, right where it it is fine. In fact, that's where it's supposed to be. You can drill out the holes to get the voltage higher, but don't go past .95. There is absolutely no noticeable difference beyond .95, except that you start to get dangerously close to 1 volt, at which point your ECM thinks you are no longer at idle, and your idle will suck. Set it to .95, MAX.

Take care
~Chris

------------------
Retired Moderator
MustangNet

My site: JimPorterRacing

RACECAR spelled backwards is RACECAR

HEY !!! Are you ASE Certified ??? If you are, ask me about iATN. The best tool you'll ever have, and it's free !!!

The stock spec on that sensor is 0.5 to 1.0 V. Mine was at 1.04 V and trust me you don't want to go that close to the wall. The car idles funny, stalls out, and has a bunch of other small problems. Keep it the way it is.

------------------
1995 Mustang GT

Thanks guys, I had drilled it but wasn't sure if you had to do that. I'll probably just end up leaving it.

------------------
1993 Mustang GT - March Ram Air & Pullies, K&N, C&L 73mm MAF, Edelbrock 65mm TB & EGR, 3.73 Gears, Super Competition Hooker Headers, 2 1/2 in. High Flow H-Pipe & 2 1/2 in. Flowmaster Cat Back, Pro 5.0 Shifter, 16* Timing Advance, 8.5mm MSD Super Cunductor Plug Wires, Romoved front Sway Bar, Nitto DragRadial, Pro-Shift Lite, LX lights