A question for 94-95 cobras with strut towers
 

I had to take off my stock strut tower because the cobra intake sits higher than the stock one. What brand tower brace will clear this intake? I heard Steeda's will. Can I use the stock holes from the stock brace to bolt in the new tower brace?

------------------
94' Stang GT Convertible --Cobra upper&lower, GT-40Y Turbo Swirl aluminum heads, Mac cold air w/K&N, BBK equal length shorties, BBK offroad H-pipe, American Thunder cat-back, BBK T/B 65mm, 24lb injectors, Pro-77mm MAM, pulleys, aluminum driveshaft, 3.55s, Steeda Tri-Ax shifter, adjustable fuel regulator 14.4@100 MPH on G-tech;96 at track. (Sad, i know. This is with the stock heads)

My Steeda strut tower brace fits fine on my Cobra. I have the stock Cobra manifold.

------------------
1995 Cobra convertible 2 Top #621 of 1,003. #184 of 499. Too many mods to list :)

The Kenny Brown fit fine on my old Cobra.

For a raised intake the Maximum Motorsports strut tower brace is piece to get. It does not cross the intake anywhere. You could remove the intake with the brace in place.

Mike

------------------
Live near St.Louis?
Check out Mustang Muscle and Dyno in High Ridge, MO
Check out my ride.