a/f ratio gauge help?
 

What one is the sending wire on the 02's so I can hook it up to the gauge?
Thanks

------------------
79 hatch w/ NA 347,stage 2 Canfield heads, out of the box Victor 5.0 intake, solid roller cam, Aeromotive fuel system, proshifted TKO II.MY CAR http://www.mustangworks.com/cgi-bin/...splay.cgi?1288
93lx all stock + tremec

You're going to have to get a schematic from Ford. That's what I did. I think it's green with purple, but I don't really remember. Once you get the schematic and find the wire, use a voltage meter to check the volts. Just poke it right through the wire and take the reading. The voltage should constantly be moving. Sorry, I've looked all over the house for the schematic but I can't find it. Good Luck!

------------------
92 GT, 4:10 gears, centerforce clutch, 6# powerdyne blower, bbk h-pipe, flowmasters

Dark Green with a Purple tracer on the right and Dark Blue with a Light Green tracer on the left.

Take care
~Chris

------------------
Retired Moderator
MustangNet

My site: JimPorterRacing

RACECAR spelled backwards is RACECAR

HEY !!! Are you ASE Certified ??? If you are, ask me about iATN. The best tool you'll ever have, and it's free !!!

I also installed a toggle so I can read the LH and RH independently, works good. I also choose to hook the wores up at the EEC instead of under the car at the O2's.

Installation instructions for a left and right DPST switch. (Radio Shack)
Red = 12v Ign. (5 amp inline fuse)
Blk = Engine grd.
Violet = Center pole of switch to the
Left switch pole = right hand oxygen sensor / number 65 (gray/blue) at EEC
Right switch pole = left hand oxygen sensor / number 66 (red/blue) at EEC

Soldier connections of jump wire at switch pole and shaved wire at EEC.


The violet wire is coming out of the back of the A/F gauge and is connected
only to the center pole of the DPST switch.
Don't cut the OEM wires to the EEC, just shave back the plastic insulation
that covers the wire and twist the wire around the exposed bare OEM wire
(65&66). You should use a pencil type soldiering iron a soldier all the
connections.


------------------
Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension, SPEC stage III clutch, Lakewood SFI bell, S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon!
<B>12.16 @ 113.5, 1.78 60ft..no traction in the 90 degree

[This message has been edited by Rick 91GT (edited 09-10-2001).]

Slick! I like that.

Take care
~Chris

------------------
Retired Moderator
MustangNet

My site: JimPorterRacing

RACECAR spelled backwards is RACECAR

HEY !!! Are you ASE Certified ??? If you are, ask me about iATN. The best tool you'll ever have, and it's free !!!

Thanks guys, that helped out allot.