Will 28x10.5" ET Streets Fit My 88 GT Without Rubbibg?
 

I Have Stock Suspension, and was wondering if 28"tall et streets will fit without rubbing?

thanks

------------------
1988 Mustang GT, T-5
3.08's, No Smog Pump (Shorty Belt), Dumps At The End Of Stock H-Pipe, K&N Air Filter (Stock Air Box), Removed Air SilencerMy Stang
My Site (Not Done Yet)

with the right off set rims and if you trim the inside lip of yor fender well off (that lil L shaped peice of metal) if fits snug but well
best of luck!
Sean

...and looks really, really good if I may add.

------------------
Todd
1995 GT/T-5
Pulleys; 65 mm TB; Flowmaster cat-back; Mac off road H-pipe; FMS aluminum driveshaft; short-throw shifter; HD clutch; Cobra R's; Cobra front and wing

Yeah they fit. I was running them on my 92 GT. I had to roll the fender and trim the interior part of the rear quarterpanel, right next to the wheel. They hook big time too. I had to take them off because they were too fragile on the street. I got several flats over the months. They were fun while they lasted though. I could eat anybody from stoplight to stoplight, easily.

------------------
92 GT, 4:10 gears, centerforce clutch, 6# powerdyne blower, bbk h-pipe, flowmasters

They will kill your rpm, you don't have enough gear or power to run those tires yet, the 26" x 10.5" would be best. The 28" tires will fit if you trim the wheel opening and bang the inner fender in, you may also need to trim the rear ground effect so that when the tires grow they do not rub.

------------------
Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension, SPEC stage III clutch, Lakewood SFI bell, S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon!
[b]12.16 @ 113.5, 1.78 60ft..no traction in the 90 degree

ok, i will go with 26x8" et streets on some stock turbine, or lx 10 hole rims and 355 gears.

thanks

------------------
1988 Mustang GT, T-5
3.08's, No Smog Pump (Shorty Belt), Dumps At The End Of Stock H-Pipe, K&N Air Filter (Stock Air Box), Removed Air SilencerMy Stang
My Site (Not Done Yet)

You should get 26x11.50. I'm running them now, They hook awesome and look bad a$$ too.

Hey spike, will the 11.5's fit on the 15X8 draglite rim? Thanks

------------------
88LX NOTCH, 88GT, 95 GT.

USMC302 Thats what I'm running on. I can't remember the backspacing though.