MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)
-   -   another transmission bites the dust (http://forums.mustangworks.com/showthread.php?t=6360)

redsn95vert 10-09-2001 03:49 PM

another transmission bites the dust
 
For the third time in two years I need another trans. Has anyone else had a problem with their aode? I can't figure out what is causing it (maby I should untie the cinder block from my foot). If anyone has any ideas let me know. The only thing I can think of is that my tranny cooler isn't doing the job and is burning the fluid.
Thanks....

------------------
95 GT convertable, 3.73 gears,Catco Hi-flo h-pipe, Flowtech headders, Cobra intake w/ 65mm tb
GT40 heads, march underdrive pullies, Saleen wires, custom made cold air induction

macx 10-10-2001 11:31 PM

although the /E's have some improvements
over the plain AOD's, they still won't
handle much power/abuse in stock configuration. There are parts in later
model 4R70W's that will retrofit, along
with non-stock control settings and parts like clutches and gearsets etc that will
cure the problems, but a swap to a particular used later model (with upgraded clutches and shift control settings) that has all those good hard parts stock (cheaper than buying those expensive parts separately!)might make sense. I sent you some info I've discovered after quite a bit of research for myself.

95 King GT 10-12-2001 01:31 AM

Hate to tell you this but a stock AODE can't handle your setup. You need to get a High Performance AODE. Level 10 is a real good one. Lentech Makes a dam good tranny, and so does transmission center. I have the one from Transmission center I love it. without a shiftkit, higher special pressure solenoid your tranmission will just burn up.

redsn95vert 10-14-2001 03:55 PM

Thanks for the help guys. I've got about 12,000mi left on the warrenty now so I've probably got one one more transmission left b4 the warrenty expires. What I was planning on doing was get a larger trany pan, aftermarket cooler, and the trans-go kit. I saw in the year one cataloge a heay duty input shaft, would that be a good idea for me?
Thanks guys

------------------
95 GT convertable, 3.73 gears,Catco Hi-flo h-pipe, Flowtech headders, Cobra intake w/ 65mm tb
GT40 heads, march underdrive pullies, Saleen wires, custom made cold air induction


All times are GMT -5. The time now is 08:05 PM.