Best BFG Comp T/A DR Tire Pressure
 

What is the best tire pressure to hook up these tires. I have BFG P275-50R-15 mounted on 10" wide 15" wheels. My best to date is 1.90 60 ft. with 13lbs. Can I go lower? 92 LX Notch dynoed at 458hp rwhp.

I usually run mine around 15-13 PSI. I've found that the trick is to heat them up. I just spin 'em in the water for a second then pull out and heat 'em till they smoke pretty good. To date I've cut low 1.8's. http://www.mustangworks.com/interact...board/wink.gif

------------------
89GT,T-5Z, D.S.S. 306 shortblock w\main support, B-303 cam, Cobra intake, GT40P heads, 1.72rr, MAC "P" headers, MAC off-road H-Pipe, MAC true-fit w\tips, 373's...and the list goes on!
Throttle Junkie Powered by Ford!
12.824 @ 107.05 MPH
PVT Blankenship leaving for BCT 14MAR01
MOS 67 Romeo

Play around with the pressures. Each car has a different set up, so you have to find what works for you.

I run mine around 10psi. My 60fts are consistently in the 1.7x to low 1.8 range.

Launch technique is important too. I ride the clutch out of the hole at around 2500 rpm & then plant the gas pedal. That's what works for my set up.

------------------
91 coupe
3.73's,long tubes,2 1/2" exh,ported stock t-body,ProM-77mm
cobra intake,edelbrock heads,B303,1.72 rr's
36lb inj's,tremec, & a Paxton NOVI 2000!!!
11.020 @128.95 on BFG Drag Radials (275/60/15)

BFG recommends 12-18psi, FYI. They also recommend no more than a quick burnout to clean them, although everyone I talk to says you need to get them hot.

------------------
Moxie Racing

Last time I went to the track I had a set of bald 255/50/16 on stock pony rims. I had them around 14-15 PSi Launching at 4000RPM after heating them up and I pulled a best of 1.77 and consistant 1.8's.

------------------
92' LX Hatch 5 spd Edelbrock Performer Intake, pro-m 75mm MAF, 70mm T.B., 24lb injectors, 190lph, Mac fenderwall cold air induction, mallary ignition and coil, Cobra 1.7 rockers, 373:1 gear, upper and lower control arms, supersubs, 50/50's, front drag springs, no sway bar, battery in hatch, compucar N20 kit
13.42 @ 100.50 N/A on radials
No time on Juice yet

Ok guys, I can't drive for crap! My best 60' are in the 2.0x range! AGGH! I think I will try to lower my pressure some considering I usually go with 20 psi or so.

E

------------------
1991 5.0 LX Coupe -37,800 miles

13.17 @ 106.14 mph w/ 2.138 60'

Pro-Charger D-1SC on the way!!!

Thanks for all the suggestions. I think I will try the 10psi as it seems to work for "sisustang".

Hey Muskrat, i've been using the bfg dr's for a few years now and I have found the best results at 14psi on my 255 dr's i pulled a best of 1.70 on a very stock suspention at the time,but u have to heat them up well,4-5sec burnout good luck

------------------
93Gt 60,000 org miles on car,Check sig in user rides for mods, 12.71@109 on 255BFG DR's CAR weighs 3560 w/me 1.70 60'

After reading all the 1.7 times out there, I will have to blame the problem on the cow pasture track I usually run at. Not to mention any names, it is in N.W. N.J.
Oh by the way I have heated these suckers about 3-5 sec.
The 1.90 60' did yield a 12.01 at 119.5
Thanks again for the input.