ballpark figure on horsepower
 

i got a 69 mustang coupe that i just recently had the motor rebuilt. It got punched out .060, a 282 comp cam, 3 angle valve job, heads decked, flat top hyperuetectics, 10:1 compression, edelbrock performer intake, edelbrock 600 carb, msd ignition, hedman headers and 2 1/2 inch flows. the guy who built it said that it had around 240-250, can someone estimate what you think i have?
thanks

I think the estimate of 240 hp is about right! I would think you would have 240hp
at the rear wheels. I good set of aftermarket heads would put you at the 300rwhp mark.

Regards,
Billgear www.289mustang.com

I would say that probably about right. What size motor do you have though??

Skyler

------------------
-1989 Saleen Mustang #406-
TFS Heads, Edelbrock intake, E-303, 3.73's, 1 5/8 shortys, Offroad-H, 2chamber flows, 36psi FPR, 15degrees timing, 70mm tb, 73mm maf, 24lb inj, Crank pulley, MSD6A, Alum driveshaft.

On its way: Paxton Sn-89 with dyno tuning and long tubes.

Just added: B&M Ripper, Weldin Subframes, & Turn downs!
13.2@106mph

oh yea you might need to know that, its a 302