Rear Bumper Guards
 

I recently purchased rear bumber guards for my '68 Mustang Fastback. I have no pre-drilled holes in the valance or the rear of car for the brackets. There are two small holes (one on each side) of the license plate area. Does anyone know the exact location the holes should be drilled for the brackets and the guards?

I just went out and looked at my 68 FB. The rear bumper guards, with the rubber strip, mount to the rear lower valance. They are about one inch or so from where the bumper comes down around the license plate. The two small holes in the bumper are for the license plate light.

I'll try and attach pic. If it doesn't go through email me and I will send pic of rear of car, hopefully that will help.