Best Cam?
 

What do you guys think would be the best cam for my setup.89 stock short block,Windsor Jr. heads,1.7 roller rockers,Edelbrock Performer RPM intake,600 cfm carb,March performance pulleys,MSD6-AL,125hp shot of nitrous with a 4-speed tranny.THANX

If it was ME,I would get a custom ground nitrous cam,you will get the most power going this route.

------------------


[This message has been edited by Mustanguy (edited 01-04-2001).]

what company would you use for a custom grind?

I used comp cams!

------------------
James Cox
nochevy@hotmail.com
1991 Mustang LX
Best 1/8 time on motor 7.686 @90.20mph

motorsport b cam

I was looking at either a E-303 or a Crane 2040 what do you think of those cams?

X-CAM!!! Ilove it!!!!!

------------------
88 NOTCH DSS 331CI C-4 BRAKE 4:10'S 11.5-1 DART IRON HEADS X-CAM 1.7 ROCKERS 8PT. CAGE BEST 10.9@125MPH 100% STREETALBE TO ME!!!

the 2040 and the e cam are the same thing. and are not designed for use with 1.7 rockers.

Spinemup,what do you think about the B cam? is it a better cam then the E cam in your opinion?What are some of the advantages of the B cam=====THANX

Wolverine 1087, but you'll need valve reliefs in your pistons and preferably and higher compression ratio.

--nathan

------------------
--silver_pilate

'91 GT, Built 306, Wolverine 1087 cam, ported Windsor Jr. Irons, and all the goodies...click the link to the left to see a full list of my mods...

Tried and True 302 Being Built to Outrun You! heh heh heh...
--Texas Panhandle--
Check out my site

Whoops...sorry, didn't catch that bit about the nitrous....the 1087 probably wouldn't work as well for you.

--nathan