I dunno Fox Body...my engine, the Z24 (2.4L) was rated at 106 Bhp....that's less than yours! I do have a 5-spd though....That would help me out a little bit....
I'm sure you would beat me though. Because PKRHED, dang it, I've done that before, I mean PKRWUD (haha...j/k....if he reads this) is in the process of helping me fix a little malfunction on my carburetor. So I'm running on 1 of 2 barrels.
You'd smoke me man...It takes me like 5 minutes just to get up to speed on the highway....ok, not QUITE 5 minutes....more like 4 1/2....hehe....j/k....
But seriously...you'd smoke me....I can't even get the tires to turn over when I sidestep the clutch from a standstill...
I did replace the rear leaf springs on it yesterday afternoon. One of them broke so I just got a set from the junkyard...kept the good one that I took off of it for a spare. But it looked like it had potential to snap like the other one.
I'm making a pretty good little truck out of it though. All new shocks, new heater motor, new heater control unit, stripped interior to just about nothing and cleaned the **** out of it, and got rid of all the old useless wiring. I think I am going to buy some new tires for it before next winter though. Or at least swap the fronts to the back. I get no traction whatsoever on ice if don't have it in 4WD. It won't move, at all.
This does remind me...after school the other day it was really icy and still a lot of snow on the ground, so me and a friend went and had some fun in the Shitsan. I got my front tires in some pretty deep snow, took it out of 4WD, and started banging gears. Had it in 4th gear with the speedo up past 80, all at a standstill....Got down to the cement though and started smoking them off...had a pretty good cloud of smoke for like 85 hp...hehe...When I put it in 4WD drive to get out of the hole I didn't move. Tried rocking it and everything. But my tires had carved a hole about 5 inches deep in ice, so my friend had to go give it a little shove to get me out of the hole. Hehe...what fun....
|