MustangWorks.com : Ford Forums - View Single Post

1985Mustang · 12-18-2001, 08:58 PM

I noticed the 2031 advertises specs assuming 1.7's. Are the 2030 specs given for 1.6's? If so I might have a problem with clearance. My exact set up is N/A, stock H.O. pistons/crank/rods, stock '85 heads with a 3-angle valve job, stock headers, stock ignition, Edelbrock performer intake (unported), and 600 cfm Edelbrock carburetor. Tranny is stock T-5 and rear end is 3.08. Tires are stock height. I really need to maintain a lot of low end power because it will mostly be driven redlight to redlight in traffic.

12-18-2001, 08:58 PM	#3
1985Mustang Registered Member Join Date: Oct 1998 Location: Knoxville Posts: 20	I noticed the 2031 advertises specs assuming 1.7's. Are the 2030 specs given for 1.6's? If so I might have a problem with clearance. My exact set up is N/A, stock H.O. pistons/crank/rods, stock '85 heads with a 3-angle valve job, stock headers, stock ignition, Edelbrock performer intake (unported), and 600 cfm Edelbrock carburetor. Tranny is stock T-5 and rear end is 3.08. Tires are stock height. I really need to maintain a lot of low end power because it will mostly be driven redlight to redlight in traffic. __________________ 1985 Mustang GT Edelbrock Performer intake, Edelbrock 600 carb, 9mm FMS wires, 15^ timing, no smog pump, 8.8 w/3.08 Last edited by 1985Mustang; 12-18-2001 at 09:04 PM..