View Single Post
Old 03-25-2001, 01:23 PM   #2
NOS_Notch
Registered Member
 
Join Date: Sep 2000
Location: Fresno,CA. USA
Posts: 384
Post

as you are looking down on the engine compartment....
lower left, very bottom is the smog pump..off the smog pump there is a steel tube that runs to the back of the heads.
there are some vac attatchments but if you looked at a boneyard car it would only take about 20 minutes to get all of it off.
make sure you get the steel tube from the y-pipe to the h-pipe. also you will need a hi-flow catalytic h-pipe( or weld the smog tube to the h-pipe) the y-pipe(which is probably gone) should now have thermactor plugs in it's place on the back side of the heads....i would say that's about it.



------------------
4.10's,long tubes & 75 shot...Goes 12.50's
Check it out at http://www.burnouts.webprovider.com
NOS_Notch is offline   Reply With Quote