MustangWorks.com : Ford Forums - View Single Post - Swapping to a Cobra intake what will I need?

Bad89stang · 01-14-2002, 11:07 PM

I am no expert, but I would use some RTV silicone around the corners between the lower and the heads. You may also want to consider gasgacinch to hold the gaskets in place. Make sure you clean all surfaces very well so that the gaskets make a good seal. Especially on the head surfaces. I am not sure of the HP gains that you will get without heads or cam, but I know that the advertised gains are with better heads and some other minor bolt on stuff.

01-14-2002, 11:07 PM	#2
Bad89stang Registered Member Join Date: Aug 2001 Location: Ft. Worth, TX Posts: 456	Things to consider... I am no expert, but I would use some RTV silicone around the corners between the lower and the heads. You may also want to consider gasgacinch to hold the gaskets in place. Make sure you clean all surfaces very well so that the gaskets make a good seal. Especially on the head surfaces. I am not sure of the HP gains that you will get without heads or cam, but I know that the advertised gains are with better heads and some other minor bolt on stuff. __________________ You're gonna need your seatbelt