MustangWorks.com : Ford Forums - View Single Post

CobraII76 · 01-22-2002, 03:46 PM

I'm afraid you will not get the block hugger headers into the car. The clearance issue is going to make that a hard fit you have a 1 1/2 inch space between the block and frame rail a motor mount a crossmember and a starter on the passenger side. the driver side has about 2 inches between the block and rail with a motor mount a crossmember again and the steering shaft. My Mustang II headers in with a 302 barely fit in. Good luck can't wait to hear how it goes.

01-22-2002, 03:46 PM	#12
CobraII76 Registered Member Join Date: Jan 2002 Location: Michigan Posts: 56	I'm afraid you will not get the block hugger headers into the car. The clearance issue is going to make that a hard fit you have a 1 1/2 inch space between the block and frame rail a motor mount a crossmember and a starter on the passenger side. the driver side has about 2 inches between the block and rail with a motor mount a crossmember again and the steering shaft. My Mustang II headers in with a 302 barely fit in. Good luck can't wait to hear how it goes. __________________ 74-78 MustangII's So many II's so Little Time.