MustangWorks.com : Ford Forums - View Single Post

93CobraR · 04-06-2001, 03:39 PM

Regarless of the miles on them Crane says you must replace them with a new cam. It evens says if you only have a dyno run on them to replace them. Now I sure wouldn't do that but I would replace them with anything over 70-80k on them. The stocks will run to fit that cam. You can get them for them for $100 from Mustang Unlimited and they're Crane. Save your self the hassel of breaking stuff, and even tearing up your new cam.

------------------
87 GT, 4 inch cowl hood,17x9 Cobra R's/255/45's,GT-40 heads,long tubes headers,h-pipe,Flows,BBK cold air, Mass air,70mm MAF, 1.7's, 1" spacer,underdrive pulleys,Pro 5.0, King Cobra, Adj. fuel Reg., Lakewood Lift Bars,50/50's,subframes, 4.10's.
Best time 12.96
Best MPH 103.42
Best 60' 1.695

Visit my site at:
http://www.geocities.com/cobrar93_2000/MyPage.html

[This message has been edited by 93CobraR (edited 04-06-2001).]

04-06-2001, 03:39 PM	#4
93CobraR Registered Member Join Date: Oct 1999 Location: Cincinnati, Ohio Posts: 1,575	Regarless of the miles on them Crane says you must replace them with a new cam. It evens says if you only have a dyno run on them to replace them. Now I sure wouldn't do that but I would replace them with anything over 70-80k on them. The stocks will run to fit that cam. You can get them for them for $100 from Mustang Unlimited and they're Crane. Save your self the hassel of breaking stuff, and even tearing up your new cam. ------------------ 87 GT, 4 inch cowl hood,17x9 Cobra R's/255/45's,GT-40 heads,long tubes headers,h-pipe,Flows,BBK cold air, Mass air,70mm MAF, 1.7's, 1" spacer,underdrive pulleys,Pro 5.0, King Cobra, Adj. fuel Reg., Lakewood Lift Bars,50/50's,subframes, 4.10's. Best time 12.96 Best MPH 103.42 Best 60' 1.695 Visit my site at: http://www.geocities.com/cobrar93_2000/MyPage.html [This message has been edited by 93CobraR (edited 04-06-2001).]