MustangWorks.com : Ford Forums - View Single Post

clearwaterms · 04-12-2001, 12:48 PM

I have a vortech with the high pressure oil inlet, and was wondering if i unhooked the high pressure line from that and then hooked up a oil cooler inline with it, if it would cause a problem with the motor. The only problem I can see is the loss of pressure because of the extra distance that it has to travel. when i was running my car without the blower last week (melted the discharge tube) it ran alot cooler. Also because im at the peak efficiency of the a-trim, it runs REALLY hot.

04-12-2001, 12:48 PM	#1
clearwaterms Registered Member Join Date: Jun 1999 Location: Westchester, IL, USA Posts: 171	oil cooler installation I have a vortech with the high pressure oil inlet, and was wondering if i unhooked the high pressure line from that and then hooked up a oil cooler inline with it, if it would cause a problem with the motor. The only problem I can see is the loss of pressure because of the extra distance that it has to travel. when i was running my car without the blower last week (melted the discharge tube) it ran alot cooler. Also because im at the peak efficiency of the a-trim, it runs REALLY hot.