MustangWorks.com : Ford Forums - View Single Post - Powerdyne tensioner problem after smaller pullie

Chipdog · 03-02-2002, 10:59 PM

After installing a smaller pullie for my 6 psi to boost to9 psi I am having problems with my serpentine belt getting shedded by one of the tensioner bolts. I have the smallest belt I can fit on the blower but I still need to drop the tensioner down far. Is there a way to get a smaller belt on the SC pullie so the tensioner could be set in the higher bolt holes? Or is there a bigger pullie for the tensioner? Right now I am running around with the blower belt off so I don't get stuck again. Man it sucks to be slow.

thanks for the help
Chip

03-02-2002, 10:59 PM	#1
Chipdog Registered Member Join Date: Apr 1999 Location: Miami,Fl USA Posts: 297	Powerdyne tensioner problem after smaller pullie After installing a smaller pullie for my 6 psi to boost to9 psi I am having problems with my serpentine belt getting shedded by one of the tensioner bolts. I have the smallest belt I can fit on the blower but I still need to drop the tensioner down far. Is there a way to get a smaller belt on the SC pullie so the tensioner could be set in the higher bolt holes? Or is there a bigger pullie for the tensioner? Right now I am running around with the blower belt off so I don't get stuck again. Man it sucks to be slow. thanks for the help Chip __________________ 92 GT Convertible Hooker Headers, Headman X pipe, Flow Masters, 4.10s, BBK 1.5 drop, 73mm Mass air, 65 FMS TB, FMS Aluminum radiator, T-5 swap with a Steeda shifter. And a 9 pound Blow Job