MustangWorks.com : Ford Forums - View Single Post

snkmug · 03-22-2002, 12:23 AM

I have a non roller cam block that I want to use stock 87-93 roller cam heads on, what pushrods do I need and how about the rockers? I will have the valve relief forged pistons installed, and have heard about a roller cam conversion you can buy, how does this work? the lifter hold down tray would have no place to screw down unless to drill and tap some holes?

03-22-2002, 12:23 AM	#1
snkmug Registered Member Join Date: Dec 1998 Location: Hatteras,NC,USA Posts: 108	Old Block, New Heads I have a non roller cam block that I want to use stock 87-93 roller cam heads on, what pushrods do I need and how about the rockers? I will have the valve relief forged pistons installed, and have heard about a roller cam conversion you can buy, how does this work? the lifter hold down tray would have no place to screw down unless to drill and tap some holes? __________________ 86 GT, March Pulleys, Off Road H-Pipe, Ultraflow/Mac Tailpipes, 3.73 gears/ AOD to T-5 Conversion/ Motorsport Wires/ Trick Flow Heads BBK headers/ F Cam/ Forged TRWS/ Cobra Intake Mass Air conversion, Bored .40 /1.6 Motorsport rockers