MustangWorks.com : Ford Forums - View Single Post

mak375 · 03-22-2002, 05:10 PM

I have a blk 94 cobra, cold air induction with a k&n, 3.73 gears, bassani x-pipe, flowmaster catback, rear upper and lower control arms, subframe connectors, and i am ordering headers.

I need help deciding what brand headers to get, and should i go equal or unequal length?

Also i am not sure where to go next. This is my daily driver, however now that i am up at school it sits in my garage for a week or two at a time. And i am looking for a beater so i can keep my miles down and keep my cobra looking nice all the time.

unfortunatly because i am a college student and right now i have no job until the summer, and even then i will not have much cash, i cannot afford stuff like a supercharger.

03-22-2002, 05:10 PM	#1
mak375 Registered Member Join Date: Nov 2001 Location: State College, PA Posts: 104	Next? I have a blk 94 cobra, cold air induction with a k&n, 3.73 gears, bassani x-pipe, flowmaster catback, rear upper and lower control arms, subframe connectors, and i am ordering headers. I need help deciding what brand headers to get, and should i go equal or unequal length? Also i am not sure where to go next. This is my daily driver, however now that i am up at school it sits in my garage for a week or two at a time. And i am looking for a beater so i can keep my miles down and keep my cobra looking nice all the time. unfortunatly because i am a college student and right now i have no job until the summer, and even then i will not have much cash, i cannot afford stuff like a supercharger.