MustangWorks.com : Ford Forums - View Single Post

glxstang · 03-26-2002, 01:43 PM

Hey all,
I started to press in some new wheel studs where the axel is out of the rear end. I used the "washers" method of putting on a bunch of washers and a old lug nut and pull the studs through until they seat. The only problem is that how in the world do I stop the axel from rotating when I apply the force to pull the studs through. Is there a special tool or am I doing something wrong.

Thanks again!

03-26-2002, 01:43 PM	#1
glxstang Registered Member Join Date: Feb 2001 Location: Delray Beach, Florida Posts: 97	Wheel Studs Installation Hey all, I started to press in some new wheel studs where the axel is out of the rear end. I used the "washers" method of putting on a bunch of washers and a old lug nut and pull the studs through until they seat. The only problem is that how in the world do I stop the axel from rotating when I apply the force to pull the studs through. Is there a special tool or am I doing something wrong. Thanks again!