MustangWorks.com : Ford Forums - View Single Post

Mad Horse · 04-20-2001, 12:06 AM

First off, your best way to figure this one out is to use the search engine and search for anything titled "First Mods" or something similar. You will be sure to find previous posts with tons of knowledge.

I don't want to leave you hanging though so I will list a few here and you will be able to find out how to do them when you search through the older posts.
1)New plugs, wires, and a brass cap and rotor (if needed)
2)Remove air silencer
3)Advance timing to around 14
4)Use synthetic oils
5)Underdrive pullies
6)Get some gears!!
I could go on but you did not list a budget or anything so..

------------------
88GT 5-speed
Mods: Cervinis Ram air hood 3.73 gears, King Cobra clutch, Pro 5.0, March alum. Pullies, DynoMax Cat-back, K&N, 9mm plug wires, PS91 coil, Accel Cap/Rotor, 190lph Fuel pump, 16" Ponies.
"Nip it in the Bud"
My Webpage

[This message has been edited by Mad Horse (edited 04-20-2001).]

04-20-2001, 12:06 AM	#2
Mad Horse Registered Member Join Date: Sep 1998 Location: Dayton, OH., United States Posts: 467	First off, your best way to figure this one out is to use the search engine and search for anything titled "First Mods" or something similar. You will be sure to find previous posts with tons of knowledge. I don't want to leave you hanging though so I will list a few here and you will be able to find out how to do them when you search through the older posts. 1)New plugs, wires, and a brass cap and rotor (if needed) 2)Remove air silencer 3)Advance timing to around 14 4)Use synthetic oils 5)Underdrive pullies 6)Get some gears!! I could go on but you did not list a budget or anything so.. ------------------ 88GT 5-speed Mods: Cervinis Ram air hood 3.73 gears, King Cobra clutch, Pro 5.0, March alum. Pullies, DynoMax Cat-back, K&N, 9mm plug wires, PS91 coil, Accel Cap/Rotor, 190lph Fuel pump, 16" Ponies. "Nip it in the Bud" My Webpage [This message has been edited by Mad Horse (edited 04-20-2001).]