MustangWorks.com : Ford Forums - View Single Post

shovelnose · 04-24-2001, 12:23 PM

This is a Dayco # 5060445. I think 44.5" long. I ran this with the set-up you are talking about. Should also work with UD pullies.

Keep in mind the WP should be a clockwise spinning pump. Your 88 will be counter-clockwise. Unless you have the idler pulley on the dr. side of the motor, then dis-regard all info.

My set-up is three pullies and alt. idler arm. The tensioner is very close to it's limits, but it works fine.

------------------
82 Mercury Capri 302.
Comp. Cams
Tremec 3550
3.73's
12.8@106 N/AKevin's Capri

[This message has been edited by shovelnose (edited 04-24-2001).]

04-24-2001, 12:23 PM	#2
shovelnose Registered Member Join Date: Oct 2000 Location: Ontario, Canada Posts: 234	This is a Dayco # 5060445. I think 44.5" long. I ran this with the set-up you are talking about. Should also work with UD pullies. Keep in mind the WP should be a clockwise spinning pump. Your 88 will be counter-clockwise. Unless you have the idler pulley on the dr. side of the motor, then dis-regard all info. My set-up is three pullies and alt. idler arm. The tensioner is very close to it's limits, but it works fine. ------------------ 82 Mercury Capri 302. Comp. Cams Tremec 3550 3.73's 12.8@106 N/AKevin's Capri [This message has been edited by shovelnose (edited 04-24-2001).]