MustangWorks.com : Ford Forums - View Single Post - Lentech Valve Body Owners: Where did you mount the O/D delete switch?

silver_pilate · 04-09-2002, 12:16 AM

I also thought about using the face plate below my CD receiver, but I've decided to mount the switch on the cover plate of the shifter. There is plenty of room on the passenger side of the plate, and it is easily removed in order to drill the hole for the switch. Also, I plan on simply drilling into the transmission tunnel near the shifter so I have less wire to route.

I'm installing the vb this weekend, and I'll take plenty of pictures and eventually put a write up on my website. I'm using a simple black rocker switch with a black mount-housing which has a small red light that comes on when switched on. Thus, red light = no OD

.

--nathan

04-09-2002, 12:16 AM	#2
silver_pilate DURKA DURKA!! Join Date: Sep 1997 Location: Lubbock, TX...(TX panhandle) Posts: 1,418	I also thought about using the face plate below my CD receiver, but I've decided to mount the switch on the cover plate of the shifter. There is plenty of room on the passenger side of the plate, and it is easily removed in order to drill the hole for the switch. Also, I plan on simply drilling into the transmission tunnel near the shifter so I have less wire to route. I'm installing the vb this weekend, and I'll take plenty of pictures and eventually put a write up on my website. I'm using a simple black rocker switch with a black mount-housing which has a small red light that comes on when switched on. Thus, red light = no OD . --nathan __________________ '91 GT, Coast 347, 9.5:1 compression, full intake, Wolverine 1087 cam, exhaust, Keith Craft ported Windsor Jr. Irons (235 cfm intake, 195 cfm exhaust), AOD, PI 3500 converter, Lentech valve body, 3.73's (4.10's in the works), and Yokohama ES100's out back. Daily Car: '04 Infiniti G35 Sedan 6MT