MustangWorks.com : Ford Forums - View Single Post

mimicons · 04-10-2002, 04:53 PM

In the instructions for connecting the guage it says to "Connect line to pressure port on engine by using 1/8" adapter and T-Fitting". My question is....Where is the best place to splice into? Has anyone installed one of these, and if so, please be as specific as you can with the location of the vaccum line, since they all look the same to me! Thanks in advance.

I've been pulling my hair out for about an hour now, and I'm no closer than I was before (just balder!).

04-10-2002, 04:53 PM	#1
mimicons Registered Member Join Date: Aug 2001 Location: Atlanta Area, USA Posts: 42	Autometer Vaccum Pressure Guage...Help In the instructions for connecting the guage it says to "Connect line to pressure port on engine by using 1/8" adapter and T-Fitting". My question is....Where is the best place to splice into? Has anyone installed one of these, and if so, please be as specific as you can with the location of the vaccum line, since they all look the same to me! Thanks in advance. I've been pulling my hair out for about an hour now, and I'm no closer than I was before (just balder!).