View Single Post
Old 04-24-2002, 04:13 PM   #1
Sonics2042
Registered Member
 
Sonics2042's Avatar
 
Join Date: Jul 2001
Location: Seattle, WA
Posts: 381
Default Anything here I don't need?! (90 LX AOD to T5)

Here is the final list I have concocted. I am pretty sure this is everything....Is there anything here I DON'T need? (just want to save money anywhere I can )

-------------------------------------------------------------------------
T-5 Transmission
T-5 Clutch Fork - 86-93
1987-1993 Pedal Assembly
Bellhousing
Clutch - 10 1/2"
Flywheel - for 10 1/2" Clutch
Flywheel Bolts
Transmission to Block Plate
Shifter
Shift Boot, Knob, Handle, Noise Barrier Weather Boot Gasket
Clutch Quadrant and Adjuster
Clutch Cable
T-5 Backup Wire Harness
Speedometer Gear to match your Gears
Pilot Bearing
Bellhousing Bolts (You can only use 2 of your AOD ones)
Pressure Plate Bolts
Clutch Cable Retainer Clip
Replacement T-5 Tail Shaft Seal
-------------------------------------------------------------------------


Thanks,
DoranW
__________________
What I have:
1990 Red Mustang 5.0 LX:
[BBK X-Pipe]-[MAC Cat-Back Exhaust]
[MAC Cold Air Intake]-[BBK Equal Shorties]
[3.55 Gears]-[Cobra Intake Manifold (Upper and Lower]
[E-303 Cam]-[Granetelli Mass Air Flow Sensor]
[Front and rear sway bars]-[New black carpet and seats.]
[Adjustable Fuel Regulator]-[T5 Conversion w/ K. Cobra Clutch/Hurst STS]
[Cobra Throttle Body]-[130A Alt. Conversion]

Thinking about:
Aftermarket Heads!
Vortech A-Trim
Sonics2042 is offline   Reply With Quote