efi dist without computer
I can't remember where I found this or even if it will work but here goes the wiring steup for using a efi dist. without a computer
starting at the bottom of the module
4 start signal (starter solenoid wire)
3 ignition switched 12 v power source
2 negative side of coil
1 ground
Like I said I don't even know if it will work but its worth a try!
good luck and let me know if it works!
__________________
88 Notchback orig. 4 cylinder car with a efi v8 swap from a wrecked 89 5.0 hatch,edelbrock performer rpm's 190/160,typhoon intake,comp cams 1.6 rockers,65mm tb and spacer,pa performance c4 w/ 3000 stall,3.73's auburn pro, 31 spline mosers,mac off road h-pipe,1 5/8 shorties ,and 2 1/2 pro dumps,kirban fpr,190 lph walbrp.
SOON TO BE BLOWN!
|