MustangWorks.com : Ford Forums - View Single Post - Having problems with vibrations after clutch install Please help.

zepherman · 05-16-2002, 11:09 PM

Just insalled a SPEC sage 1 clutch. After instaling it, i feel horrid vibraions through the shifter between 2500 and 3000 rpm. with the trans in neutral, i rev the engine and i can feel a little vibrtion as it passes the same rpm. The clutch works fine mechanically except for the vibration. Everything was fine before i put in the new clutch. I installed the previous clutch with no problems. i replaced everything but the pilot bearing because it was replaced last time and it wasnt that long ago. I also had th flywheel resurfaced by a local O'reillys.

Thanks for your time,
Adam

05-16-2002, 11:09 PM	#1
zepherman Registered Member Join Date: May 2001 Location: Oklahoma City OK USA Posts: 236	Having problems with vibrations after clutch install Please help. Just insalled a SPEC sage 1 clutch. After instaling it, i feel horrid vibraions through the shifter between 2500 and 3000 rpm. with the trans in neutral, i rev the engine and i can feel a little vibrtion as it passes the same rpm. The clutch works fine mechanically except for the vibration. Everything was fine before i put in the new clutch. I installed the previous clutch with no problems. i replaced everything but the pilot bearing because it was replaced last time and it wasnt that long ago. I also had th flywheel resurfaced by a local O'reillys. Thanks for your time, Adam __________________ 90 GT 25th Anni. Did the AOD to T-5 swap, SPEC clutch, Steeda Tri-Ax shifter, BBK 2½ inch off-road H pipe, Flows, BBK 70mm TB/EGR, Ford Racing aluminim driveshaft, 3.55's, welded subframes, Ram Air, 3 core radiator, NOS dry kit 75 shot, and a K&N filter. 12.9 @ 108