Juat another fun week of racing a mustang!!
This post also has another lesson....IF I CAN DO IT...SO CAN YOU!!!!!
Two weeks ago, my car runs a 10.71 @ 126mph.
347 Stroker
Energy Cam 276/280 duration 690 lift.
Solid Roller
750 HP Carb
TF Street Heat Heads
Edelbrock Vr.Jr. Intake
C4
4.56
33 Spline Moser Spool
4000 Stall
(Car is NOT gutted at all, full interior).
Last week, it runs a 11.30 at 122mph.......UHHH SOMETHING IS VERY WRONG HERE!!!
Take Care Sunday to Engine guy, goes to turn engine over by hand and it is "Too hard to turn" he has great concerns....YEAH ME TOO!!!!
So, to save a buck, I trailer car back home and pull Motor out by myself...(Never done that before. Allot of fun...NOT!!!)
Pull drive shaft, drop exhaust, pull motor and trans out...yadda...yadda.
Take motor to my Engine Builder.....he says one of the cam bearings has walked out. But caught it in time, other then one of hte rollers was banging into it....fun!!
While he fixes that, I send stall off to Trans. Spec, in PA to get stall loosened to 5000.
I get motor and Stall back this past friday.
I then spend friday afternoon and saturday TRYING to get the car back together by Race Day sunday. By myself! Putting Stall in Trans, trans on motor, all into the car, hook everything back up and FINALLY start it up Saturday night. If fires right up.
Load on trailer Sunday morning and go to track...
10.75 @ 126.............Back in business............Gheeesshhhhh.......talk about a marathon week.
As I said, if I can learn as I go taking it all out and putting it all back in...well........I dont' know what that means.......maybe I just go lucky?
James
|