MustangWorks.com : Ford Forums - View Single Post

RPM427 · 06-06-2002, 06:36 AM

I just got a response from joe at mustang magic:

"Ryan; sorry to say you can't run 2.02 intake valve with stock pistons unless you use Twisted Wedge heads. The valve relieves are not wide enough for a 2.02 intake. Joe @ Mustang Magic"

I wanted to go with the 185's cause i'm probably going to get a 396 short block in a when its time for a new engine. I will probably go with the 185's then.

Does anyone know how much lift/duration i can go with the 165's with the smaller valves using 1.6 rocker?

06-06-2002, 06:36 AM	#9
RPM427 Registered Member Join Date: Aug 2001 Location: Huntington NY Posts: 573	I just got a response from joe at mustang magic: "Ryan; sorry to say you can't run 2.02 intake valve with stock pistons unless you use Twisted Wedge heads. The valve relieves are not wide enough for a 2.02 intake. Joe @ Mustang Magic" I wanted to go with the 185's cause i'm probably going to get a 396 short block in a when its time for a new engine. I will probably go with the 185's then. Does anyone know how much lift/duration i can go with the 165's with the smaller valves using 1.6 rocker? __________________ -1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! Last edited by RPM427; 06-06-2002 at 10:47 AM..