Fan Switch Wont Work???
Ok i've had the manual fan switch on the car for quite some time now and last night it wouldnt turn on, no problem I think, get it the garage today and redo the wire all pretty like, and it still wont work. When I flip my switch I can hear a clicking noise from under the hood but the fan wont turn on. The blade moves freely so I know the motor isnt shot and the computer still turns it on, just I cant, WTF. Can I hook up a wire to one of the three that go to the fan itself or no? Any help would be appreciated.
__________________
**MODERATOR AT WWW.COLORADOSTANGS.COM**
Cobra upper and lower intake, bbk 70mm throttle bodie, mac cold air kit,
bbk/walbro 190lph fuel pump, pro m 75mm bullet mass air meter, jet computer chip, bbk lowering springs (1.5"), D&D adjustable upper rear controll arms, Indexed spark plugs,
gripp caster/camber plates, under drive pullys, msd 6al ignition, msd blaster coil, taylor 10.5mm plug wires, bassani exhaust with an x, saleen ceramic headers, 3:73 gears, E-303 cam,1.6 roller rockers, aeromotive adjustable fuel pressure regulator, cobra r clutch, 180 thermostat, manual fan on/off switch (high), msd shift light, autometer volt, water and air/fuel carbon fiber, everything inside car, white faced guages, hurst pro 5.0 shifter,
Pro-M Remote Optimizer
And finally a new trans so now I can race again
Next up, some suspension work.
**Working on traction issue**
1/4 mile- 14.85@91mph at 5800ft above sea level
60'- 2.12
1/8 mile 9.52@72mph
Just some fyi, my times would be about this at sea level:
1/4 mile- 13.6
60'-1.8 or 1.7
1/8 mile- 8.2
|