MustangWorks.com : Ford Forums - View Single Post

Rick 91GT · 05-13-2001, 10:24 AM

Once you get them to 0 lash, you go 1 turn. I went 1 turn on mine and they ended up too tight I had to go in and re adjust and go 3/4 turn. If the rockers are too tight the motor will not rev and have any power you will need to re-adjust them. Here's a link to Crane Cams Installation Instruction of Alum Stud Mount Rocker arms. http://64.90.9.168/cranecams/pdf/425e.pdf

If that doesn't work go to www.cranecams.com installation instructions

------------------
Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension,S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon!

[This message has been edited by Rick 91GT (edited 05-13-2001).]

05-13-2001, 10:24 AM	#2
Rick 91GT Procharged! Join Date: May 1999 Location: Hanover, PA Posts: 1,539	Once you get them to 0 lash, you go 1 turn. I went 1 turn on mine and they ended up too tight I had to go in and re adjust and go 3/4 turn. If the rockers are too tight the motor will not rev and have any power you will need to re-adjust them. Here's a link to Crane Cams Installation Instruction of Alum Stud Mount Rocker arms. http://64.90.9.168/cranecams/pdf/425e.pdf If that doesn't work go to www.cranecams.com installation instructions ------------------ Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension,S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon! [This message has been edited by Rick 91GT (edited 05-13-2001).]