View Single Post
Old 06-12-2002, 11:14 AM   #5
Stang_ROTY
Registered Member
 
Stang_ROTY's Avatar
 
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
Default

Windsor is just the name of the city where the engine's were built. Obviously, the 351 Cleveland's were built in Ohio. As far as the swap goes, a lot depend on if you are running EFI or a carb. EFI will cost a lot more. I put a 393 in my car and needed to get new oil pan, headers, distributor, etc. The h-pipe needed to be bent to accomodate the extra 1.5 in. of engine width. I also needed to get a EFI 351 lower base to match the Edelbrock upper plenum and a hood to accomodate the extra inch or so of engine height. The biggest decision you need to make is if you are going to go EFI or carb. Good luck!
__________________
Red 1993 GT Street Machine
Best E.T. - 12.41/Best MPH = 108
Engine is a 1969 351 block w/393 stroker kit. Dynamic Roller Myte C4, 8 pt cage. Edlebrock Performer heads and Victor Jr. EFI, FRPP 30lb injectors & Cartech fuel system. MSD ignition. Sothside Machine bars & Sub-frames, adj. upper's, 3.73's, Koni rear shocks, much more
Stang_ROTY is offline   Reply With Quote