MustangWorks.com : Ford Forums - View Single Post

sleeperstang · 06-19-2002, 10:08 PM

Fordmuscle.com has an article on their website where they test a number of heads, including stock 289 heads, ported 289 heads, Edelbrock, Holley, Brodix, World, and other aftermarket heads. It should make for a good read, unfortunately you have to shell out either the $5 bucks for a monthly membership or I think $15 buck for an annual membership.

I have yet to subscribe, but I probably will go ahead and shell out the money to see their testing. It's all done on a flow bench at Mondello technical school. Hope this brings some good info to ya.

06-19-2002, 10:08 PM	#7
sleeperstang Registered Member Join Date: Jun 2001 Location: Lynwood, CA, U.S.A. Posts: 82	Fordmuscle.com Fordmuscle.com has an article on their website where they test a number of heads, including stock 289 heads, ported 289 heads, Edelbrock, Holley, Brodix, World, and other aftermarket heads. It should make for a good read, unfortunately you have to shell out either the $5 bucks for a monthly membership or I think $15 buck for an annual membership. I have yet to subscribe, but I probably will go ahead and shell out the money to see their testing. It's all done on a flow bench at Mondello technical school. Hope this brings some good info to ya. __________________ 65 Mustang Coupe...Comp Cams 262 Xtreme Energy, T-5 conversion, Romac Balancer, 620 Front Springs-4.5 Mid-eye rear springs.......work in progress