MustangWorks.com : Ford Forums - View Single Post

RPM427 · 06-20-2002, 07:37 AM

I agree that the MM brace is by far the best one on the market.

If you wanted to make uninstallation quicker you could insert the bolt from the underneath and tack weld it in place. Then you can take the brace on or off without a second wrench. Make sure you drill all of the holes and tighten everything BEFORE you weld so you can be sure everything lines up. You can put rubber covers, similar to vacum caps on the ends of the studs top make it look more presentable. Good luck.

06-20-2002, 07:37 AM	#3
RPM427 Registered Member Join Date: Aug 2001 Location: Huntington NY Posts: 573	I agree that the MM brace is by far the best one on the market. If you wanted to make uninstallation quicker you could insert the bolt from the underneath and tack weld it in place. Then you can take the brace on or off without a second wrench. Make sure you drill all of the holes and tighten everything BEFORE you weld so you can be sure everything lines up. You can put rubber covers, similar to vacum caps on the ends of the studs top make it look more presentable. Good luck. __________________ -1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out!