Porting GT-40P Upper and Lower with a Dremel
Does anyone have any input on porting a GT-40P Upper and Lower with a Dremel? Is there anything I should know before getting into it? I'm new to this so any input would be appriciated. If anything I would like to smooth out the ports for less restricted airflow. But I would like to actually make the ports bigger also. I know this will be a slow process, but it's a learning one at that.
__________________
89 LX Hatch 5.0 5spd, alot of miles, terrible 2.73's, mac cai, pullies, Tri-Ax, 16* timing, elect fan, 3G alt
Best to date: 14.331@97.46mph with 14*/stock fan/short belt and a 2.222 60' in 90 degree weather
Waiting to put on Off road H and 1 5/8 headers
Rice Hater's Club #36
|